Cut lines on the inside AND outside of a circle?

Hi all! I’ve attached a link to this, but basically I want the inside and the outside of the circle to be cut out with the imprint in the middle…any ideas? Or just cut it with a similar sized circle once complete?
Ta :slight_smile:

https://app.cookiecad.com/?settings={"purchaseSize"%3A3,"cutterSize"%3A40,"sizeType"%3A"longest","interiorType"%3A"imprint","imprintDepth"%3A"2","bladeDepth"%3A"9","bladeThickness"%3A"0.4","extraBladeDepth"%3A11.9,"extraBladeThickness"%3A0,"baseHeight"%3A"3","baseWidth"%3A"3","horizontalBarWidth"%3A0,"verticalBarWidth"%3A0,"units"%3A"mm","invertInterior"%3Afalse,"offsetIn"%3Afalse,"offsetInner"%3A0.3,"forceSolidBar"%3Afalse,"mirror"%3Afalse,"removeImprintBase"%3Atrue,"stampCutterTolerance"%3A0.9,"stampBackHeight"%3A4.5,"stampImprintHeight"%3A3,"deleteOuterPath"%3Atrue,"cutterSet"%3Afalse,"userSize"%3A40,"currentStlOutputFile"%3A"776f99cb34ab4a70a13842d79e10e91b%2050W%20V8.stl","name"%3A"278429855_716531839537175_5883987528258854000_n"}

Hi,

If you want to cut and imprint you would need to make two separate pieces. You can make a cutter that cuts both the outside and inside (see: How to create a 3d printed doughnut cutter with center cut out using Cookiecad) but it can’t also have an imprint. So for the imprint you can just make a separate stamp.

thanks Nathan :slight_smile: will do that!