Filament issue, not sticking to itself

Hello. Had anyone have this issue with Creality Cr6 se?
Uploading: 3C2DC491-AB4B-4F16-9BA1-B608B41C35D0.jpeg…

Hi, I think you may have left the page too soon before the image finished uploading. Can you edit the post and add the image?

Check in your printer display menu if there is a setting called “E in mm3” or “volumetric mode” that is on, and if it is turn it off and see if that resolves the issue. I don’t have a CR6 but if the setting exists it might be under filament settings.