Imprint - define hole height

Hi Nathan, thanks for your patience and attention!
I am trying to create a wheel model as shown in the attached picture. I see that the “Imprint Cutter” base function is able to perfectly reproduce the hole in the middle of the image and by activating the center bar option I am able to connect the two black circles.

Then, the “imprint” subfunction let me define the height of the red dots inside the wheel (I would like to define a lower height for the red dots).

My problem is that the outer and inner black circles have a different height, and I would like to define the same height for them. Is there a way to let the “Blade” subfunction to consider the inner circle? this could solve my issue.

Thanks again!

At the moment, everything inside the shape is considered imprint and there is no way to have a different height for different parts of the imprint.

Hi Nathan, any news about this topic?

Thanks again and again :wink: