New to 3d printing and having some issues!

Hi everyone, I’m Amie I’m new to 3-D printing I print with an Ender 3 S1 I’m having some teething issues. I’m getting lots of stringing on my prints that I’m unable to remove even with a craft knife! I’m using PLA PET G I have read that it may be moisture in my filament, but I’ve even opened a new role and I’m still having the same issues

I had similar issues, I have since eliminated sting art by making sure you have a silicon packet in the storage container housing your filament. I now also use the following; eSUN eBOX – eSUN Offical Store. It heats up the entire PLA spool to decrease the moisture.

Hope this helps