Solid fill vs. See thru cutter (for clay cutters)

Brand new to the printing world of clay creations here… and I apologize if this has been covered already but for the life of me I can not figure out how to make my cutters see through vs. having a solid fill (the part that is against the build plate) If I get clay stuck in these cutters, I have to dig it out verse push it out from the other side.
Guidance is greatly appreciated <3 I attached pictures. The cutter with the see through bottom is a file I purchased off Etsy. The solid fill cutter is one I created here.


Check the box under experimental settings → remove base under imprint

image

I officially feel dumb now LMAO Thank you!!

I couldn’t find how to remove this base, I think I’m getting very blind. The options I found are just these:

It only shows up if you select “imprint cutter” in the first drop down under thing to make.