Wiggle blades for polymer Clay

Hi there,
I would to design my own set of wiggle blades for polymer clay, however I am stumped as to how to make the center thick. It is like a standard cutter except the center wiggle is the thick part with a 1mm cutting edge. Can anyone help with this please… I have so many lines I want to create, but so stumped as to how to get it right.

Thanks in advance… Newbie here

If I understand correctly, you want that shape to be a blade. There are a couple of ways you could try going about this. One is to select imprint cutter, then set blade thickness to 0. That will make just the imprint show up like so:

image

To get the right thickness for the imprint you might need a little trial and error but you can adjust it using experimental settings → thicken interior. Use a positive number to make it thicker and a negative number to make it thinner.

You did, woo hoo, thankyou so much!!! I am so happy I could cry tears of joy. The top needs to have a blade edge of 1mm as you would any polymer clay cutter. This has helped me no end Thankyou

1 Like